Subaru WRX Forum banner

TGV problem (bank open) in WRX 2005

6K views 2 replies 2 participants last post by  Paddydee 
#1 ·
hello
hi i get Subaru Impreza WRX 2.0T 2005 (UK version), this is good car, i like buy subaru since long time ago and now i have it :) since week i have problem with TGV. this the fault code

P2011 TGV - INTAKE MANIFOLD RUNNER CONTROL CIRCUIT/Open bank2a

so i buy new sensor and new control electric engine, i change over, delete fault from ECU but after engine run the fault back again, i try do this 5-6 times but i cant remove fault from ECU, the bank is open now so any way that should be fine but i need repair it and delete fault. i dont know where i can find reason of this problem

thanks for any help :)
 
#2 · (Edited)
If your sure the replacement parts are good your next step should be checking the harness. Check the wiring harness from the tgv to ecm for cuts, broken wires, wires pulled out of connector pins, or any other damage. You can also test resistance and continuity from one end to the other. Also check connectors for broke, loose, corroded, or missing pins and anything that would cause a bad connection. If all this checks out, start checking grounds.

Sent from AutoGuide.com Free App
 
#3 ·
thanks for replay, i will check connection btwin ecu and tgv in weekend, i find in service manual step by step how check cables so we see... i like ask u in UK version he ECU is located at left (pasanger) side or like in EU version at right ?

thanks
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top