Subaru WRX Forum banner

Installing a JDM Twin scroll turbo, heaer and up-pipe

4K views 1 reply 2 participants last post by  psinuse 
#1 ·
I am installing a VF37 and JDM Header on my USDM EJ205 that is going in my FFR 818R. Currently the engine is out of the car on a stand and mocking up the install. Header and up pipe bolted up, turbo installed. The turbo is very close to the lower manifold which looks like I will have interference with the turbo inlet.
I have found little information on this swap, is there something I am missing? To be fair I only have spent an hour on my mock up, any advice on this swap is appreciated.

Thanks
 
#2 ·
The turbo sits the same distance from the intake on a single scroll as it does on a twin scroll. I have this set up on my new motor and other than the up pipe being a bit bigger(two pipes instead of one) everything else is pretty much the same. Might wanna do the TVG deletes since the motors are always in the way.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top