|
The PEME has 4 wires, by now the green & black should be hooked up to something (the white wire)
Now for the 2 gray wires... While you were taking apart the loom you may have found a bunch of wires plugged into a black clip. This is the "Shield & Sensor Ground Joint Connector" the other wire is located here.
Find the BLUE wire with RED tracer & cut. Add on a length of wire suitable to extend it long enough to reach the PEME.
I don't believe that the gray is polarity sensitive, BUT hook it up like it would be under the car... green side gray to connector side wire, black side gray to loom side wire...
Cover ALL connections so no bare wires are exposed... I recommend shrink wrap &/or 3M brand Super +33 electrical tape ( just over $3 a roll )
|