I ordered a kit for my friend's Cobalt SS SC and we installed it last night. It went flawlessly, but I wanted to post some info on here for 02-03 Bugeye owners who will be installing the exact same kit as the Cobalt. It uses a 9007 Hi/Lo kit and so does the Bugeye. This actually applies to ALL HID kits, but we used the SharpHID 9007 HI/Lo 55W kit in 6000K. It looks beautiful, but the wiring is really the only part people may have difficulty with. I thought I'd take the time to clarify for everyone with an '02-'03. I made a simple little diagram to show which wires do what. Keep in mind, our Subies run a common power and switched ground for almost everything in our cars. That is why a little tutorial is required. The center connection on the 9007 is ground on most cars, but it happens to be the power for a Subaru. Looking at the car connector, to the right is the low beam circuit and to the left is the high beam. SharpHID's kit came with the battery harness so you only wire up one headlight and there's no need to do this on both. Wiring it incorrectly will make your fog lights also not work properly, just FYI. I spent about an hour trying to figure out the lights on my '02. Also, you'll need to flip the "9006" connector (it's the connector that every HID kit I've ever seen uses, it's the connection coming right off the ballast - the oval one). On the SharpHID kit it also came with zip ties so that's what you'll use to hold them together as it won't "clip" on like when you're running it on most cars. - - - SharpHID will have to correct me if I'm wrong there, because it may already be setup to accept reverse polarity like a regular 9007 bulb. - - - Everything else is literally plug and play. I have to say that I've purchased at least 10 sets of HIDs for my personal cars, and this is by far the nicest kit I've ever seen. That's my review. But here's the diagram to help with the wiring. Sorry that the image didn't upload 100%, all the vital stuff is there.
