I don't have a photo of this process but it's quite easy. You're just removing the tape backing as you go long making sure that everything is lines up as you go. So, start pulling from one end little by little, and keep making sure the top of the visor is aligned with the window trim and press down to insure that the tape sticks until you get to the very back. Be careful not to tear the backing.
Now you can press the A brackets in place. They just click in. 5 per side, there are little holes on the bottom side of the visor which match up to the screws that hold down that piece of metal under the trim. There are actually 6 spots I realized, but that's fine. Just look at the included instructions to figure out where the 5 clips go.
Now the C clip was interesting to figure out. This is how it should look.
You can put the soft rubber molding back in place now.
