After all this time stored away must have angered the beast..
The most expensive Clutch Alignment tool..
All said and done it was a productive weekend.. The motor is in and almost done.. I sent out my fuel injectors for cleaning and I have a couple little odds and ends to finish up before I fire her up for the first time but it's getting close.. Friday is my goal.. Let’s see if I can make it..
This time around all the exhaust piping is Jet Hot coated then Wrapped and lastly silicone coated.. I will NEVER wrap pipes again.. What a pain and my hand is still sore.. The block is an Axis Stage 5. Darton sleeves, CP (Short) pistons, Forged Rods and Crank, fully balanced to 10,000 rpms.. Now once I upgrade the oil delivery system I will be able to rev that high, however that's on the next time around..