Step 8
Make your ground 'harness. Technically you don't really have to do this step as it is more work, but I did it to make it look clean and professional. Basically, two of the 4 connections on your relay go to ground. So I made a Y wire so only one connection goes to the chassis. I used the soldering iron for this, heatshrink, the 2 F connectors, and a single eye loop that goes to the chassis.
Step 9
I tapped the Y connector I just made into ground from one of the bolts holding down the shifter as it was a close and conviennent location.
If you've done everything right thus far, you should have 4 wires with 4 F crimps on each all comming to the center console. Two of the four wires being grounded to the chassis.
